Sharing is Caring.. =)

[zorathenne]

Okay last time I'm sharing my Cisco~gasm today.. Got review for midterm to finish then my errands to run today..

But.. I feel the need to share my triumph today..
I didn't get to finish what we needed to do (none of us did cause of something that was going on in the beginning)

Alright you Cisco peoples (if any of you happen to read this..) If you can tell me what I was trying to do.. I'll give you a cookie!



Resource Control Module (RCM_2_00_15)
Telnet Proxy


Connection established with client: [208.229.253.150:3539]


+--------------------------------------------------------------------+
| Please specify your username and password below. Once your access |
| privileges have been verified, you will be redirected to your |
| destination device. |
+--------------------------------------------------------------------+


@UID
Proxy Username: user10
@PWD
Proxy Password:

HELP
----
You are connected to the RCM Telnet Proxy service. You must select a
device to which you want to connect to. At the device selection
prompt you may list the devices by selecting 'L'. The device list
will identify each device with a descriptive name of the device

To select a device, simply enter the device ID
For example, entering '7' selects device #7.

Dev ID Dev Name Dev Type
------ ------------ ------------
109 2520-WG10RA cisco:2500
209 1912-WG10SDA cisco:190
309 2514-WG10UIA cisco:2500

@DEV
Select a device [#, L, Q, ?]: 109
@AOK

[RCM PROXY: connecting to device...]
[RCM PROXY: connected]


Connected - Press ENTER for device prompt

User Access Verification

Password:
wg10-router>en
Password:
wg10-router#config t
Enter configuration commands, one per line. End with CNTL/Z.
wg10-router(config)#int bri 0
wg10-router(config-if)#shutdown
wg10-router(config-if)#
00:22:09: %LINK-5-CHANGED: Interface BRI0, changed state to administratively dow
n
wg10-router(conf
00:22:09: %LINK-3-UPDOWN: Interface BRI0:1, changed state to down
00:22:09: %LINK-3-UPDOWN: Interface BRI0:2, changed state to down
wg10-router(config-if)#int s0
wg10-router(config-if)#encapsulation frame-relay
wg10-router(config-if)#no shutdown
wg10-router(config-if)#
00:22:52: %LINK-3-UPDOWN: Interface Serial0, changed state to up
wg10-router(config-if)#
00:23:03: %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0, changed state
to up
wg10-router(config-if)#end
wg10-router#
00:23:35: %SYS-5-CONFIG_I: Conf
wg10-router#show frame-relay pvc

PVC Statistics for interface Serial0 (Frame Relay DTE)

Active Inactive Deleted Static
Local 0 0 0 0
Switched 0 0 0 0
Unused 1 0 0 0

DLCI = 109, DLCI USAGE = UNUSED, PVC STATUS = ACTIVE, INTERFACE = Serial0

input pkts 9 output pkts 1 in bytes 1776
out bytes 34 dropped pkts 0
in BECN pkts 0 out FECN pkts 0 out BECN pkts 0
in DE pkts 0 out DE pkts 0
out bcast pkts 1 out bcast bytes 34 Num Pkts Switched 0

pvc create time 00:01:03, last time pvc status changed 00:00:53
wg10-router#show frame-relay map
Serial0 (up): ip 10.1.101.1 dlci 109(0x6D,0x18D0), dynamic,
broadcast,, status defined, active
wg10-router#ping 10.1.x1.1
Translating "10.1.x1.1"...domain server (255.255.255.255)
% Unrecognized host or address, or pr

wg10-router#ping 10.1.X1.1
Translating "10.1.X1.1"...domain server (255.255.255.255)
% Unrecognized host or address, or protocol not running.

wg10-router#ping 10.1.101.1

Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 10.1.101.1, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 28/31/32 ms
wg10-router#config t
Enter configuration commands, one per line. End with CNTL/Z.
wg10-router(config)#int s0
wg10-router(config-if)#shut
wg10-router(config-if)#no ip a
00:36:08: %LINK-5-CHANGED: Interface Serial0, changed state to administratively
down
00:36:09: %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0, changed state
to down
wg10-router(config-if)#no ip address
wg10-router(config)#int s0.1 point-to-point
wg10-router(config-subif)#ip address 10.1.101.2 255.255.255.0
wg10-router(config-subif)#frame-relay interface-dlci 109
wg10-router(config-fr-dlci)#int s0
wg10-router(config-if)#no shut
wg10-router(config-if)#
00:49:49: %LINK-3-UPDOWN: Interface Serial0, changed state to up
00:49:50: %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0, changed state
to up
wg10-router(config-if)#end
wg10-router#
00:49:56: %SYS-5-CONFIG_I: Configured from console by console



Okie me go now *wiggle*

Comments

[xevilcarebearx.livejournal.com]

Can I ask you where you got your icon? Ive seen a few...cept with different hair and stuff, and yeah I think its spiffy.

Thanks so much<3

[zorathenne.livejournal.com]

Here hon.. This is the site for making the icon.. =)

http://www.dookyweb.com/index.php?seccion=avatars

Sorry it took so long booness. Been having a busy time =)

The sangria made it all worth it though *giggle*

*huggle*!!